APC Pure Logo webp
shopping_cart 0 search menu

DIY Candle Making

Candle making is the perfect way to create a personalised gift. Alternatively, keep them for yourself and enjoy the cosy vibe.

Important Note: Prior to using any of the products mentioned, it is highly recommended to thoroughly read and understand all safety precautions associated with each product. It is also strongly advised to perform a patch test before proceeding with usage.

Please be advised that this guide is intended for informational purposes only and APC Pure cannot accept any responsibility for the outcome of any usage based on this guide.

Here are the materials you'll need:

  • Paraffin Wax
  • Wicks (Opt for larger wicks if following this guide)
  • Fragrance Oils
  • Double Boiler
  • Heat-resistant Containers (Anything that can withstand heat works)
  • Thermometer
  • Spatula

Step 1: Cover your workspace with newspaper or paper towels and gather your spatula, thermometer, and other supplies. Have your containers and wicks ready as the process is swift.

Step 2: Secure the wick to the container. As the wax melts, it will form a pool of liquid. Dip the metal tab of the wick into the melted wax and quickly adhere it to the bottom of the container. After a couple of minutes, the wax will harden, keeping the wick in place. Alternatively, you can use adhesive pads. To keep the wick in the centre, consider using a closed peg on top of the container.

Step 3: Using a double boiler, melt the wax. Fill the bottom pan with an ample amount of water and place about half a pound of wax in the double boiler (this quantity is suitable for an 8oz mason jar). Stir the wax and break up any large chunks with the spatula. The wax typically takes 10-15 minutes to melt. Monitor the temperature closely. It should reach around 85 to 95 degrees Celsius. If the temperature gets too high, remove from the heat.

Step 4: Allow the melted wax to cool for a few minutes. We recommend pouring the wax into the container when it reaches a temperature between 75 to 85 degrees Celsius, but this is just a guideline. Pay attention to your thermometer as this process doesn't take long.

These temperatures are an approximate

Step 5: Once the wax has cooled slightly, proceed with the first pour into the container. As the paraffin wax cools, it will shrink in size, so you'll need to do a second pour to fill the container to your desired level.

Step 6: Measure the desired amount of fragrance oil and pour it into the double boiler with the melted wax. Stir for about 30 seconds to ensure the fragrance is evenly distributed.

Step 7: As the paraffin wax cools further, you may notice a small sinkhole in the middle and the wax pulling away from the edges of the jar. This is normal. To address these issues, reheat the remaining wax

 in the double boiler and carefully top off the candle. Be cautious not to add too much, as it may create another hole.

Step 8: Trim the wick down to approximately 5mm. A longer wick can cause the candle to burn too intensely and produce excessive heat.

Step 9: Now it's time to clean up any residual wax. If the wax is still in liquid form, wipe it away using paper towels. Caution: Do not rinse wax down the drain or put tools in the dishwasher, as it can clog your pipes. Simply use disposable paper towels or rags. If the wax hardens, it can be scraped off.