Say Goodbye to Rust

Rust can be a common problem for tools, resulting from a chemical reaction known as iron oxide. It's crucial to protect your tools from moisture to prevent rusting. We have three methods for removing rust.

Important Note: Prior to using any of the products mentioned, it is highly recommended to thoroughly read and understand all safety precautions associated with each product.

Please be advised that this guide is intended for informational purposes only and APC Pure cannot accept any responsibility for the outcome of any usage based on this guide.

Acetic Acid Method

Acetic Acid 6% is a powerful rust remover and can quickly eliminate small rust spots.

Here are the materials you'll need:

• Acetic Acid 6%
• Distilled Water
• Bucket
• Gloves

Step 1: Place your tools in a bucket and pour the Acetic Acid 6% over them. It's best to use a large bucket to ensure complete soaking of all tools.

Step 2: Let the tools soak in the solution for one day.

Step 3: Drain the Acetic Acid 6% and rinse the tools thoroughly with Distilled Water.

Sodium Hydrogen Carbonate Method

Sodium Hydrogen Carbonate is effective in dissolving dirt, grease, and rust.

Here are the materials you'll need:

• Sodium Hydrogen Carbonate
• Distilled Water
• Bucket
• Brush

Step 1: Pour Sodium Hydrogen Carbonate into a large bucket.

Step 2: Add Distilled Water to create a paste-like mixture.

Step 3: Apply the paste to the rusted areas and let it sit for a few hours.

Step 4: Once the tools have soaked, scrub off the paste using a brush.

Oxalic Acid Method

Oxalic Acid is widely used for rust removal as it converts insoluble iron compounds into soluble complex ions.

Here are the materials you'll need:

• Oxalic Acid Dihydrate 99.6%
• Distilled Water
• Bucket

Step 1: Start by washing the tools using the Sodium Hydrogen Carbonate method mentioned above. This step ensures thorough cleansing, removing dirt and oil from the tools.

Step 2: Add one gallon (4 litres) of Distilled Water to a container large enough to hold both the water and your tools. Adjust the amount of Oxalic Acid according to the water quantity.

Step 3: Carefully add three tablespoons (45 millilitres) of Oxalic Acid to the Distilled Water, ensuring you mix the acid and water without splashing it on yourself or the surrounding area.

Step 4: Place your tools in the container, allowing them to soak in the acid solution for 20 minutes. The acid requires time to break down the rust. Note: Unlike other methods, you do not need to scrub the rust when using Oxalic Acid. The acid will do the work for you.

Step 5: Rinse the tools thoroughly with clean water and dry them completely using a cloth. Proper drying is crucial to prevent rust from returning.

Remember, if your tools remain wet, there is a risk of rust returning, so ensure they are completely dry before storage or use.