Welcome Candy Collectors - DIY Halloween Flubber

Halloween season is upon us, and what better way to celebrate than by making your very own flubber?

Important Note: Prior to using any of the products mentioned, it is highly recommended to thoroughly read and understand all safety precautions associated with each product. It is also strongly advised to perform a patch test before proceeding with usage.

Please be advised that this guide is intended for informational purposes only and APC Pure cannot accept any responsibility for the outcome of any usage based on this guide.

Here are the materials you'll need:

• Water
• PVA glue
• Food colouring
  
• Sodium Tetraborate (Borax) 5% Solution

Step 1: In a container, mix 1 1/2 cups of warm water, white glue, and a few drops of food colouring. For a spooky effect, consider using orange, red, or purple colours!

Step 2: In a separate container, mix 1 1/3 cups of warm water and 3 teaspoons of Sodium Tetraborate (Borax) 5% Solution.

Step 3: Gradually pour and mix the Sodium Tetraborate (Borax) 5% Solution into the glue mixture until they are fully combined.

Step 4: Place the flubber on a tray and let it stand for a few minutes. After the waiting time, you can start playing with it!

Store in an airtight container for maximum use